https://www.soliforum.com/topic/6367/need-slicer-abs-filliment-defaults/ Wed, 07 May 2014 15:23:19 +0000 PunBB https://www.soliforum.com/post/55882/#p55882 Thanks. I'll try those settings when I get home

]]> Wed, 07 May 2014 15:23:19 +0000 https://www.soliforum.com/post/55882/#p55882 https://www.soliforum.com/post/55850/#p55850 Start with a filament diameter of 1.75mm and extrusion multiplier of about 0.80 (0.80-1.00 is pretty normal)
I use an E3D hot end, so my temps are 240 first layer / 230 the rest, but for a stock hotend start around 210.
I'm not a huge believer in accurate measurement of filament diameter, but certainly do a wall thickness calibration for the extrusion multiplier.

]]> Wed, 07 May 2014 04:05:55 +0000 https://www.soliforum.com/post/55850/#p55850 https://www.soliforum.com/post/55823/#p55823 In slic3r (SD2) under the filament setting referring to Diameter and Extrusion Multiplier for ABS. What defaults to people have? I was messing with the settings and I think I totally messed them up.

]]> Wed, 07 May 2014 01:05:48 +0000 https://www.soliforum.com/post/55823/#p55823