SoliForum - 3D Printing Community — Power supply adapter missing

Re: Power supply adapter missing

null@example.com (wardjr) — Tue, 29 Apr 2014 01:06:39 +0000

Your welcome. It's always the little things that get in the way of progress

Re: Power supply adapter missing

null@example.com (gf4mac) — Tue, 29 Apr 2014 00:48:06 +0000

wardjr,
Thank you very much.... I am Up and Running!

Re: Power supply adapter missing

null@example.com (wardjr) — Tue, 29 Apr 2014 00:31:51 +0000

Blue on bottom black on top

Re: Power supply adapter missing

null@example.com (wardjr) — Tue, 29 Apr 2014 00:29:00 +0000

They go directly to the green screw terminal block on the bottom right.

Re: Power supply adapter missing

null@example.com (grob) — Tue, 29 Apr 2014 00:28:55 +0000

[edit thanks ward]

With the blue/black wires, be very careful to ensure you get the positive and negative around the right way, it's not obvious! Check and double check with a volt meter before you turn it on, as the penalty for failure is a dead board.

Power supply adapter missing

null@example.com (gf4mac) — Mon, 28 Apr 2014 21:12:04 +0000

Can I wire my adapter directly to the mother board?

I pulled my Solidoodle 2 out of storage to generate a new project. When I started to plug it in, I noticed that the adapter was missing. I do not know what happened, or how it happened but it appears as if the male adapter from the power adapter and the female adapter for the motherboard have been stripped.

Looking at the photo, can I attach the blue and black wires from the adapter directly to the the prongs on the motherboard?