SoliForum - 3D Printing Community — Infill Slic3r question and ABS Plastic question

Re: Infill Slic3r question and ABS Plastic question

null@example.com (MartinFahrer) — Sat, 26 Apr 2014 01:20:34 +0000

michael.t.albers wrote:

Grats Martin! Fortunately, you live in one of like ten cities you can get filament from a store. Those of us without that resource either buy four to six rolls at a time or get filastruders.

I learned my lesson always have at least 1 extra spool in stock.

Re: Infill Slic3r question and ABS Plastic question

null@example.com (michael.t.albers) — Fri, 25 Apr 2014 15:27:10 +0000

Grats Martin! Fortunately, you live in one of like ten cities you can get filament from a store. Those of us without that resource either buy four to six rolls at a time or get filastruders.

Re: Infill Slic3r question and ABS Plastic question

null@example.com (MartinFahrer) — Wed, 23 Apr 2014 15:05:23 +0000

Thanks for the conformation. Yes I'm in NYC and did find some locally.

Re: Infill Slic3r question and ABS Plastic question

null@example.com (AZERATE) — Wed, 23 Apr 2014 13:50:11 +0000

You are correct on the infill. .9 would be a 90% infill density, whereas .1 would be 10%

To pick up locally in NY....NYC or state? If you are close to Brooklyn you could buy some from Solidoodle in store.

Infill Slic3r question and ABS Plastic question

null@example.com (MartinFahrer) — Wed, 23 Apr 2014 13:29:45 +0000

Infill Slic3r - I have been on the slicer web page and didn't find the answer, I am assuming a .4 fill is more dense than a .1 fill? Am I correct?

ABS Plastic - Is there a retailer in NY (Brick and mortor) where I can buy spools of ABS plastic I ran out and don't have time to order it by mail a project is due and I have to reprint due to bad Rep Rap settings, its an 18+ hour print :-(.

Thanks
Martin