<![CDATA[SoliForum - 3D Printing Community — replacing extruder ? Any experience ?]]> https://www.soliforum.com/topic/603/replacing-extruder-any-experience/ Wed, 21 Nov 2012 00:10:54 +0000 PunBB <![CDATA[Re: replacing extruder ? Any experience ?]]> https://www.soliforum.com/post/5309/#p5309 Thanks, new hot end installed. I didn't have the take the acrylic parts apart, so that helped.

Everything seems ok now, I'll run a few test to be sure.
And I need to adjust the Z heigth again I'm guessing smile

Thanks a lot !

]]> Wed, 21 Nov 2012 00:10:54 +0000 https://www.soliforum.com/post/5309/#p5309 <![CDATA[Re: replacing extruder ? Any experience ?]]> https://www.soliforum.com/post/5308/#p5308 Just the hot end.
Thanks for the link, I will go through it to figure if I need to disassemble everything or if i can just get the hot end out

From the look of it, I need to take it out of the extruder assembly.

]]> Tue, 20 Nov 2012 23:49:25 +0000 https://www.soliforum.com/post/5308/#p5308 <![CDATA[Re: replacing extruder ? Any experience ?]]> https://www.soliforum.com/post/5307/#p5307 Did they send the whole acylic extruder, or just the hot end?

Try this post - http://www.soliforum.com/topic/235/extr … bly-guide/

]]> Tue, 20 Nov 2012 23:41:52 +0000 https://www.soliforum.com/post/5307/#p5307 <![CDATA[replacing extruder ? Any experience ?]]> https://www.soliforum.com/post/5305/#p5305 Has anyone here replaced their extruder ?
Where to start ? I am asking here, because solidoodle support was supposed to let me know the steps when i got the extruder, and since I just got it, and they aren't available until tomorrow well, you know how it is !

I saw the post on the wiki about not taking it apart, but I think it's needed to replace the extruder, I plan on going slow and taking notes.
Anything else I should watch out for ?

Thanks !

]]> Tue, 20 Nov 2012 23:32:03 +0000 https://www.soliforum.com/post/5305/#p5305