<![CDATA[SoliForum - 3D Printing Community — connect a fan]]> https://www.soliforum.com/topic/5915/connect-a-fan/ Thu, 20 Mar 2014 20:26:49 +0000 PunBB <![CDATA[Re: connect a fan]]> https://www.soliforum.com/post/52591/#p52591 elmoret wrote:
wardjr wrote:

No that is roughly 5 volts you need 12 for a fan.

You sure? Schematic shows 12v on JP18 and JP19.

Actually I am not sure on that board your info is better than mine.  I was going with error on the side of caution.

]]> Thu, 20 Mar 2014 20:26:49 +0000 https://www.soliforum.com/post/52591/#p52591 <![CDATA[Re: connect a fan]]> https://www.soliforum.com/post/52589/#p52589 wardjr wrote:

No that is roughly 5 volts you need 12 for a fan.

You sure? Schematic shows 12v on JP18 and JP19.

]]> Thu, 20 Mar 2014 20:24:38 +0000 https://www.soliforum.com/post/52589/#p52589 <![CDATA[Re: connect a fan]]> https://www.soliforum.com/post/52588/#p52588 I grabbed a 12v power supply, a 3 pin extension, and a 4 way splitter from Amazon for probably $25.
I power 2 40mm fans and the 30mm fan for my E3D. Works great, simple solution.

]]> Thu, 20 Mar 2014 20:09:04 +0000 https://www.soliforum.com/post/52588/#p52588 <![CDATA[Re: connect a fan]]> https://www.soliforum.com/post/52587/#p52587 No that is roughly 5 volts you need 12 for a fan.

]]> Thu, 20 Mar 2014 19:58:19 +0000 https://www.soliforum.com/post/52587/#p52587 <![CDATA[connect a fan]]> https://www.soliforum.com/post/52586/#p52586 Hi

A quick question:

Can I connect a fan at the outlet of the LED Ligts? I need to cool down a motor that gets a little too warm.

]]> Thu, 20 Mar 2014 19:56:56 +0000 https://www.soliforum.com/post/52586/#p52586