SoliForum - 3D Printing Community — surface won't stick to bed

Re: surface won't stick to bed

null@example.com (adrian) — Mon, 10 Mar 2014 01:12:44 +0000

no - the glass is just a proxy for the alu bed in the case of the solidoodle...

If you want to add a glass sheet ontop - there is numerous numerous threads about beds on the forum....

Re: surface won't stick to bed

null@example.com (jasonpa) — Mon, 10 Mar 2014 00:48:16 +0000

I removed the white backer and stuck it to the metal heat bed. I used the method in the video, but I do not have a piece of glass. Am I supposed to have the piece of glass, how would that attach?

Re: surface won't stick to bed

null@example.com (ronsii) — Sun, 09 Mar 2014 20:40:38 +0000

I assume you are talking about the kapton tape square---> http://store.solidoodle.com/index.php?r … duct_id=61 when you say gold colored thing... did you remove the backer from the kapton square... I am guessing you bought a kapton square???

Here is a vid of replacing(from a roll of kapton tape) using the wet method ---> https://www.youtube.com/watch?v=A6y8St1q2LM

surface won't stick to bed

null@example.com (jasonpa) — Sun, 09 Mar 2014 19:39:28 +0000

the gold colored thing (don't know what it is called) had ripped so I bought a new one. I used the polising pad included then cleaned with acetone. It won't stick to the bed. I installed it when bed was warm, then I reinstalled it when cold. Can I glue it?