<![CDATA[SoliForum - 3D Printing Community — Hot End Issue....]]> https://www.soliforum.com/topic/5786/hot-end-issue/ Sat, 08 Mar 2014 14:01:26 +0000 PunBB <![CDATA[Re: Hot End Issue....]]> https://www.soliforum.com/post/51658/#p51658 cujo3131 wrote:

Not that I can see.... can't scroll all the way back in the log...

I recently had a thermistor issue which seemed to be a loose/broken
wire issue... I am wording if this too might be the problem... though
I did check all the connections...

Matt

Sure you can  scroll back.  Temperature tab, Time Period, then select the hour before.

]]> Sat, 08 Mar 2014 14:01:26 +0000 https://www.soliforum.com/post/51658/#p51658 <![CDATA[Re: Hot End Issue....]]> https://www.soliforum.com/post/51646/#p51646 Not that I can see.... can't scroll all the way back in the log...

I recently had a thermistor issue which seemed to be a loose/broken
wire issue... I am wording if this too might be the problem... though
I did check all the connections...

Matt

]]> Sat, 08 Mar 2014 00:46:26 +0000 https://www.soliforum.com/post/51646/#p51646 <![CDATA[Re: Hot End Issue....]]> https://www.soliforum.com/post/51644/#p51644 Any errors in the log???

]]> Sat, 08 Mar 2014 00:38:03 +0000 https://www.soliforum.com/post/51644/#p51644 <![CDATA[Hot End Issue....]]> https://www.soliforum.com/post/51643/#p51643 Seems I have another gremlin....

I was printing a nice print earlier and ran to the store to pick something
up... less that 20 minutes... come back....

Print has failed and hot end is ice cold....

1. I checked all the plug and they appear to be connected correctly...

2. There does not seem to be any visible damage to the hot end...

3. Thermistor is working correctly and displaying a temp....


What is going on... and how do I check to see if some went bad with the hot end?

Matt

]]> Sat, 08 Mar 2014 00:20:23 +0000 https://www.soliforum.com/post/51643/#p51643