SoliForum - 3D Printing Community — Need E3D help

Re: Need E3D help

null@example.com (Dandean) — Fri, 28 Feb 2014 23:30:29 +0000

Still haven't got control of repetier yet. Only home buttons. I cant turn my bed heater on. I uninstalled repetier and reinstalled 09.5. And still have same problem. When I changed to e3d I didn't change anything on board. I used same cord on power supply when I changed that out also

Re: Need E3D help

null@example.com (wardjr) — Mon, 24 Feb 2014 02:04:10 +0000

Re: Z-Stop Just put the screw in from the bottom.
Re: Loose fan shroud If it bothers you put a small hole in each side near the rear of the shroud and run a wire through and twist the ends together.

Re: Need E3D help

null@example.com (Dandean) — Mon, 24 Feb 2014 01:56:40 +0000

Didn't work. Maybe it's repieter and the update I did. I'll put all my stls in a folder and reinstall
How much would you charge me for a mk5

Re: Need E3D help

null@example.com (satman49) — Sun, 23 Feb 2014 22:54:06 +0000

I noticed sometimes that the x/y wont work til I heat the bed a bit, have you tried that? If you can get it to work,print the MK5. it has tabs on both sides ,rt side is for x stop screw. put a screw on the left.That stopped the fan shroud from spinning

Need E3D help

null@example.com (Dandean) — Sun, 23 Feb 2014 20:19:09 +0000

Have sd2. Installed mk4/ e3d / updated to repieter vo.90c. I was running older version that was out jan 13. Before firmware update it said to make sure printer manual controls work.
None of x and y and z buttons work but home buttons work. , any ideas? Plus. The the fan motor and shroud is loose on e3d . How do they tighten those up so they don't swivel around.
The e3d fit pretty good into mk4 but will have to do a z stop extender .