<![CDATA[SoliForum - 3D Printing Community — Slicer stalling]]> https://www.soliforum.com/topic/5465/slicer-stalling/ Sun, 09 Feb 2014 06:42:36 +0000 PunBB <![CDATA[Re: Slicer stalling]]> https://www.soliforum.com/post/49101/#p49101 I am using Slic3r 1.0.0 RC2  ,speed boost?

]]> Sun, 09 Feb 2014 06:42:36 +0000 https://www.soliforum.com/post/49101/#p49101 <![CDATA[Re: Slicer stalling]]> https://www.soliforum.com/post/49100/#p49100 Slic3r 1.0.0 RC2 is out and is in my opinion many times better than any of the older versions.  There are very few rough edges left on the new release, and the speed boost alone makes it worth the upgrade.

]]> Sun, 09 Feb 2014 06:14:41 +0000 https://www.soliforum.com/post/49100/#p49100 <![CDATA[Re: Slicer stalling]]> https://www.soliforum.com/post/49010/#p49010 MolecularConcept wrote:

rjp350z  thanks! that seemed to clear it up for now!

No problem.  There are several issues already posted on the Github for Slic3r already - Ho[e it is fixed in the next release.

]]> Sat, 08 Feb 2014 01:55:41 +0000 https://www.soliforum.com/post/49010/#p49010 <![CDATA[Re: Slicer stalling]]> https://www.soliforum.com/post/49008/#p49008 rjp350z  thanks! that seemed to clear it up for now!

]]> Sat, 08 Feb 2014 01:48:44 +0000 https://www.soliforum.com/post/49008/#p49008 <![CDATA[Re: Slicer stalling]]> https://www.soliforum.com/post/48969/#p48969 I had similar issue and had to turn off "AVOID CROSSING PERIMETERS" as it seemed to cause slic3r to hang.

]]> Fri, 07 Feb 2014 17:22:32 +0000 https://www.soliforum.com/post/48969/#p48969 <![CDATA[Re: Slicer stalling]]> https://www.soliforum.com/post/48968/#p48968 That's odd how many perimeters do you have it set for.  The problem may be in the support I designed, that support was designed at .42 so if your extrusion is set to .48 that might be causing your problem.  Since it is designed in support the slicer doesn't treat it as support.

]]> Fri, 07 Feb 2014 17:22:23 +0000 https://www.soliforum.com/post/48968/#p48968 <![CDATA[Slicer stalling]]> https://www.soliforum.com/post/48967/#p48967 this is getting to be very annoying. anytime i tell slic3r to slice a model that is the tinyest bit complicated it stalls on the last part "exporting Gcode to blah blah blah"  it wont finnish slicing. in small simple stuff it slices fine but the bulldog linar carrriage for exaple its been sitting for an hour on the last step of slicing... its been doing thissince i upgraded to 95F

]]> Fri, 07 Feb 2014 17:08:14 +0000 https://www.soliforum.com/post/48967/#p48967