<![CDATA[SoliForum - 3D Printing Community — Auger too big]]> https://www.soliforum.com/topic/5443/auger-too-big/ Thu, 06 Feb 2014 00:37:47 +0000 PunBB <![CDATA[Re: Auger too big]]> https://www.soliforum.com/post/48785/#p48785 Thanks I will email.  Taking a closer look at the auger it actually it flares out a bit. It will only go in to that point at which it binds completely. Checking it with a caliper shows that it not consistently the same diameter.

Jacqueline

]]> Thu, 06 Feb 2014 00:37:47 +0000 https://www.soliforum.com/post/48785/#p48785 <![CDATA[Re: Auger too big]]> https://www.soliforum.com/post/48773/#p48773 That seems odd, as I've been testing them before they go out.

At any rate, sure - email me at filastruder@gmail.com and I'll get you set up with a replacement.

]]> Wed, 05 Feb 2014 23:16:54 +0000 https://www.soliforum.com/post/48773/#p48773 <![CDATA[Auger too big]]> https://www.soliforum.com/post/48770/#p48770 Hi - the auger that came with my Filastruder (serial #787) is several thousandths of an inch larger than the pipe. Needless to say, it is not fitting into the pipe. The pipe was FULLY deburred. Should I be asking for a replacement?

Thanks -Jacqueline

]]> Wed, 05 Feb 2014 23:12:05 +0000 https://www.soliforum.com/post/48770/#p48770