https://www.soliforum.com/topic/5399/prints-coming-apart-because-they-are-too-stingy/ Mon, 03 Feb 2014 01:53:15 +0000 PunBB https://www.soliforum.com/post/48498/#p48498 180 is more than high enough for PLA.  Try calibrating your flow rate http://solidoodletips.wordpress.com/201 … flow-rate/

]]> Mon, 03 Feb 2014 01:53:15 +0000 https://www.soliforum.com/post/48498/#p48498 https://www.soliforum.com/post/48494/#p48494 i was printing at 195 so i raised it to 200 with no difference am i printing at too high a temp ? I read that white pla is good at 180 degrees

]]> Sun, 02 Feb 2014 23:41:27 +0000 https://www.soliforum.com/post/48494/#p48494 https://www.soliforum.com/post/48439/#p48439 Yeah, for better bonding between layers try raising the temp a few degrees as long as the extrusion and flow rates are calibrated.

]]> Sun, 02 Feb 2014 05:18:28 +0000 https://www.soliforum.com/post/48439/#p48439 https://www.soliforum.com/post/48431/#p48431 Hi so I just finished the spool mount and while it was printing i notice the layers were a bit stringy, afterwards when trying to take the piece of it came apart and was very weak. I am printing with white PLA on a non heated bed what could be the cause ? im guessing temp. because i just started using pla and i am trying to find the right temperature to print with it , any other suggestions welcomed

]]> Sun, 02 Feb 2014 03:26:19 +0000 https://www.soliforum.com/post/48431/#p48431