<![CDATA[SoliForum - 3D Printing Community — Help Me Dial In]]> https://www.soliforum.com/topic/5200/help-me-dial-in/ Thu, 16 Jan 2014 16:21:38 +0000 PunBB <![CDATA[Re: Help Me Dial In]]> https://www.soliforum.com/post/46947/#p46947 Bed at 200, extruder at 100

]]> Thu, 16 Jan 2014 16:21:38 +0000 https://www.soliforum.com/post/46947/#p46947 <![CDATA[Re: Help Me Dial In]]> https://www.soliforum.com/post/46944/#p46944 what temp do you have the extruder set to?

]]> Thu, 16 Jan 2014 15:50:42 +0000 https://www.soliforum.com/post/46944/#p46944 <![CDATA[Re: Help Me Dial In]]> https://www.soliforum.com/post/46940/#p46940 Adjusted the multiplier. Went from .75 to .70

Printed the key again, scaled slightly up, at .1 mm. Still need to trim some of the brim off in places, and there are definitely artifacts

]]> Thu, 16 Jan 2014 15:43:14 +0000 https://www.soliforum.com/post/46940/#p46940 <![CDATA[Re: Help Me Dial In]]> https://www.soliforum.com/post/46864/#p46864 I'll give that a try. Anything else?

]]> Wed, 15 Jan 2014 21:36:04 +0000 https://www.soliforum.com/post/46864/#p46864 <![CDATA[Re: Help Me Dial In]]> https://www.soliforum.com/post/46854/#p46854 Looks like you are still over extruding.  try dialing back the Extrusion multiplier a little

]]> Wed, 15 Jan 2014 17:32:04 +0000 https://www.soliforum.com/post/46854/#p46854 <![CDATA[Help Me Dial In]]> https://www.soliforum.com/post/46846/#p46846 So far I have done the following:
- calibrated extruder and flow rate
- glass bed, leveled
- adjusted tension in belts
- acrylic enclosure

I've only printed parts for the enclosure, so I wanted to try something else. I printed the Key to Eribor from The Hobbit off Thingiverse at mostly default settings (.3 mm with support)

Tonight I'm going to bump up the resolution to see what that looks like. Any other suggestions to help me get the most out of my prints?

]]> Wed, 15 Jan 2014 15:24:56 +0000 https://www.soliforum.com/post/46846/#p46846