<![CDATA[SoliForum - 3D Printing Community — 2 Problems!]]> https://www.soliforum.com/topic/5193/2-problems/ Wed, 15 Jan 2014 02:39:58 +0000 PunBB <![CDATA[Re: 2 Problems!]]> https://www.soliforum.com/post/46808/#p46808 ok thank you

]]> Wed, 15 Jan 2014 02:39:58 +0000 https://www.soliforum.com/post/46808/#p46808 <![CDATA[Re: 2 Problems!]]> https://www.soliforum.com/post/46807/#p46807 Start by lubricating the rods It looks like your belts need to be aligned.  Do a quick search it'll pop up

]]> Wed, 15 Jan 2014 02:39:09 +0000 https://www.soliforum.com/post/46807/#p46807 <![CDATA[Re: 2 Problems!]]> https://www.soliforum.com/post/46804/#p46804 ok, that answers the 2nd question, but what calibration should i do?

]]> Wed, 15 Jan 2014 02:36:08 +0000 https://www.soliforum.com/post/46804/#p46804 <![CDATA[Re: 2 Problems!]]> https://www.soliforum.com/post/46802/#p46802 It looks like you could stand to do some calibrations and lubrication.  As far as the loop that is why your printing that loop is to get the filament to the tip of the nozzle.

]]> Wed, 15 Jan 2014 02:34:31 +0000 https://www.soliforum.com/post/46802/#p46802 <![CDATA[2 Problems!]]> https://www.soliforum.com/post/46797/#p46797 Hello

1. There are small holes in my prints, and I dont know what to do to fix them (See pic)

2. When I start printing, It makes a lot of noise, and then it only prints half of the line of filament that surrounds the object, but then starts printing the object fine

]]> Wed, 15 Jan 2014 02:22:03 +0000 https://www.soliforum.com/post/46797/#p46797