https://www.soliforum.com/topic/5050/extruder-head-hits-bolts-at-front-outside-corners/ Sat, 04 Jan 2014 05:28:10 +0000 PunBB https://www.soliforum.com/post/45739/#p45739 it's just how the design is... even if the bolts were shorter the printhead would still hit the nut or pulley mount, if you are worrying about interference just limit the travel in the print bed setup.

]]> Sat, 04 Jan 2014 05:28:10 +0000 https://www.soliforum.com/post/45739/#p45739 https://www.soliforum.com/post/45728/#p45728 Mine does this too.  It arrived in May 2013.  Luckily, I've never needed to use those two corners.

]]> Sat, 04 Jan 2014 03:50:25 +0000 https://www.soliforum.com/post/45728/#p45728 https://www.soliforum.com/post/45726/#p45726 Yep, same problem and feeling as you. It hasn't warranted a fix yet from me, but definitely a silly design problem. Mine was manufactured in Octoberish 2012 and I hypothesized they ran out of the right parts since no one else has complained.

]]> Sat, 04 Jan 2014 03:24:44 +0000 https://www.soliforum.com/post/45726/#p45726 https://www.soliforum.com/post/45646/#p45646 the bolts that hold the belt pulleys for carriage at front top both sides are 3/4 inch too long and restrict head from using either front corner of print surface by same amount due to hitting them. come on! did nobody see this issue when assembling at Solidoodle??? really? anyone else have this issue? I noticed it when doing adjustments on surface hieght. never printed anything that wide yet luckily. the screws are like twice as long as needed and protrude way in from both sides. no room for this already in that area.

]]> Fri, 03 Jan 2014 06:41:47 +0000 https://www.soliforum.com/post/45646/#p45646