<![CDATA[SoliForum - 3D Printing Community — Rumba Controller Switchover?]]> https://www.soliforum.com/topic/5025/rumba-controller-switchover/ Wed, 01 Jan 2014 16:24:47 +0000 PunBB <![CDATA[Rumba Controller Switchover?]]> https://www.soliforum.com/post/45496/#p45496 Okay, So I shorted my Rev-E Motherboard back before christmas and STILL have not recieved a replacement from them.  It is beyond aggravating.  So I figured I might as well make some improvements!  I have done a LITTLE Research, and so far I think im going to go with the Rumba.  Is this going to basically just be plug in, install drivers, and play?  I would love to get back to printing ASAP.  Any help/advice/suggestions are definitely welcome!  Thanks!
I was looking at this board:
http://www.reprapdiscount.com/electroni … board.html
Will I need to buy these for it or are they built in?
http://www.reprapdiscount.com/electroni … river.html



BUMP: Anyone please? D:

]]> Wed, 01 Jan 2014 16:24:47 +0000 https://www.soliforum.com/post/45496/#p45496