<![CDATA[SoliForum - 3D Printing Community — Ending Gcode]]> https://www.soliforum.com/topic/4962/ending-gcode/ Wed, 25 Dec 2013 02:09:52 +0000 PunBB <![CDATA[Re: Ending Gcode]]> https://www.soliforum.com/post/45085/#p45085 Hazer

That's exactly what the problem was.

Thank You very much for the info.

]]> Wed, 25 Dec 2013 02:09:52 +0000 https://www.soliforum.com/post/45085/#p45085 <![CDATA[Re: Ending Gcode]]> https://www.soliforum.com/post/45060/#p45060 Park position in RH. Under Printer Settings -> Printer tab.

]]> Tue, 24 Dec 2013 12:23:57 +0000 https://www.soliforum.com/post/45060/#p45060 <![CDATA[Ending Gcode]]> https://www.soliforum.com/post/45059/#p45059 Slidoodle2. Using Repetier .95C with Slic3r.

What would make my printer home to front left after a print.
I have removed any custom End Gcode.
The only code at the end of the Gcode file is G92 E0 and M107. Which i have not put there, i guess it is generated the file?
Yet when the print is finished it will start the beginning code then go to the Front Left corner. If i kill the print it will start the beginning code then go to the front left corner aslo.

I have tried a typical End Gcode of: G28 ; Home all Axes
G1 Z5 F5000 ; Lift Nozzle.  It will do this then start the beginning code then back to the front left.

I don't know why it started to do this. Any suggestions?

]]> Tue, 24 Dec 2013 11:46:14 +0000 https://www.soliforum.com/post/45059/#p45059