I will check if the cross travel moves are a different color. 

It does appear though that it is actually extruding a full bead on the cross moves and not just oozing.

I will try remodeling the part as a shell instead of a solid and see if that makes a difference.

Ever get this resolved?

It does appear though that it is actually extruding a full bead on the cross moves and not just oozing.

I will try remodeling the part as a shell instead of a solid and see if that makes a difference.

If I understand you correct, does the extruder extrude tiny strings of filament from on side to the other?
Have you checked the Retraction settings? This will retract the filament when it is travels in just air.

At first I thought that this was the issue to but its extruding 'solid' strings from one side to the other between layers not just 'wisps' of filament.

The graphics screen in Pronterface shows the line too so I think that it is being coded that way.

Thanks for the input.

I am trying to print a hollow cylinder which was originally modeled as a solid. 

I know that I could shell this in my modeling software but I thought that I would be essentially doing the same thing setting fill to 0% in Skeinforge and perhaps adding a shell but when I print it still prints lines across the hollow area of the cylinder.

It looks like a bird's nest inside when I am done......