<![CDATA[SoliForum - 3D Printing Community — Very ugly artifacts when printing]]> https://www.soliforum.com/topic/4906/very-ugly-artifacts-when-printing/ Thu, 19 Dec 2013 10:18:38 +0000 PunBB <![CDATA[Re: Very ugly artifacts when printing]]> https://www.soliforum.com/post/44733/#p44733 COASTER19 wrote:

The artifacts do not appear in the g-code visualization, so I'd be very surprised if this were the stl or slicers fault.  I've never seen anything like this however, so don't totally rule them out.  Have you seen this behavior on any other prints?

Yes, on the other prints I see the same things. Apparently it began after I switch from the use of Pronterface to the Repetier-Host, it can be?

]]> Thu, 19 Dec 2013 10:18:38 +0000 https://www.soliforum.com/post/44733/#p44733 <![CDATA[Re: Very ugly artifacts when printing]]> https://www.soliforum.com/post/44662/#p44662 The artifacts do not appear in the g-code visualization, so I'd be very surprised if this were the stl or slicers fault.  I've never seen anything like this however, so don't totally rule them out.  Have you seen this behavior on any other prints?

]]> Wed, 18 Dec 2013 22:58:13 +0000 https://www.soliforum.com/post/44662/#p44662 <![CDATA[Re: Very ugly artifacts when printing]]> https://www.soliforum.com/post/44644/#p44644 Briggs wrote:

3d, did you run your stl through Netfab first?

Why Netfab? This issue happened with all similar models, directly downloaded from thingiverse, and with my own-maded. For .stl repairing i use Materialize Magics. How Netfab can help me in this case?

]]> Wed, 18 Dec 2013 19:15:02 +0000 https://www.soliforum.com/post/44644/#p44644 <![CDATA[Re: Very ugly artifacts when printing]]> https://www.soliforum.com/post/44642/#p44642 3d, did you run your stl through Netfab first?

]]> Wed, 18 Dec 2013 18:39:41 +0000 https://www.soliforum.com/post/44642/#p44642 <![CDATA[Very ugly artifacts when printing]]> https://www.soliforum.com/post/44604/#p44604 Appear on the surface with a small reverse bias. Has anyone seen anything similar?
Use Slic3r 1.0.0RC1 and Repetier-Host from last Solidoodle package download.
Thread when printing does not sag, does not fall, it's okay.

]]> Wed, 18 Dec 2013 09:35:51 +0000 https://www.soliforum.com/post/44604/#p44604