<![CDATA[SoliForum - 3D Printing Community — SD3 enclosure: temperature problems?]]> https://www.soliforum.com/topic/4731/sd3-enclosure-temperature-problems/ Fri, 06 Dec 2013 23:46:02 +0000 PunBB <![CDATA[Re: SD3 enclosure: temperature problems?]]> https://www.soliforum.com/post/43483/#p43483 Main thing to watch out for is your X-axis stepper motor. Mine got hot enough to warp its mounting carriage as seen in this thread:

http://www.soliforum.com/topic/3798/hot-stepper-motors/

]]> Fri, 06 Dec 2013 23:46:02 +0000 https://www.soliforum.com/post/43483/#p43483 <![CDATA[Re: SD3 enclosure: temperature problems?]]> https://www.soliforum.com/post/43303/#p43303 Thank you. Good to know. I already have a glass bed and use hairspray so hopefully no more warping! big_smile

]]> Thu, 05 Dec 2013 06:30:04 +0000 https://www.soliforum.com/post/43303/#p43303 <![CDATA[Re: SD3 enclosure: temperature problems?]]> https://www.soliforum.com/post/43203/#p43203 It most certainly did for me!  Combined with a glass bed and the occasional bit of hairspray (on the glass), warping prints are no longer a problem.

]]> Wed, 04 Dec 2013 04:29:29 +0000 https://www.soliforum.com/post/43203/#p43203 <![CDATA[Re: SD3 enclosure: temperature problems?]]> https://www.soliforum.com/post/43201/#p43201 Thank you! Yes, the heat is coming from the printer only (no external sources of heat) so it should be fine! smile

Do you know if enclosing the printer sides helps reducing the warping probem?

]]> Wed, 04 Dec 2013 04:15:19 +0000 https://www.soliforum.com/post/43201/#p43201 <![CDATA[Re: SD3 enclosure: temperature problems?]]> https://www.soliforum.com/post/43098/#p43098 No, I wouldn't worry about overheating assuming the bed and extruder are the only source of heat.  The closest I've gotten to overheating is when I put one of these: http://www.amazon.com/Lasko-100-MyHeat- … B003XDTWN2 in with my printer, and even then the stepper motors were fine, the filament just began to be ground by the extruder gear.

]]> Tue, 03 Dec 2013 06:16:45 +0000 https://www.soliforum.com/post/43098/#p43098 <![CDATA[SD3 enclosure: temperature problems?]]> https://www.soliforum.com/post/43090/#p43090 I recently completely closed off all sides of the printer (see image). I did it to keep dust out when it is idle and heat in when it is printing! However, I am concerned about too much heat when it is printing. Does anyone know if enclosing the cage will result in too much heat that will damage the printer (melts parts, etc)?

There is a 0.5"x2" horizontal slot in the back of the top cover where the filament comes in but I am not sure that is enough ventilation.

Feedback is much needed and appreciated.

]]> Tue, 03 Dec 2013 05:11:46 +0000 https://www.soliforum.com/post/43090/#p43090