SoliForum - 3D Printing Community — Modelling from Lightwave

Re: Modelling from Lightwave

null@example.com (cmetzel) — Tue, 06 Nov 2012 15:51:39 +0000

Solidoodle doesn't love angles of more than 45 degrees, although it can be done with a fan and slow speeds. Think about how it prints, how it slices and how the material will be laid down from the bottom up as you're designing. If you have something that starts halfway up the part (hands on this model for example) and there's nothing below them, solidoodle will try to lay down filament there, but the filament will just droop down to the bed and most likely ruin your print.

What you can do in your skeinforge or slic3r software is enable support material. This will allow you to print whatever but you'll have to remove the support material when you're done, it will work but won't look as good.

Re: Modelling from Lightwave

null@example.com (ysb) — Tue, 06 Nov 2012 10:54:54 +0000

the center pannel between the legs will perhaps be a problem...

Modelling from Lightwave

null@example.com (Nakaleen) — Tue, 06 Nov 2012 04:39:38 +0000

While I am ok at Lightwave, I am trying to learn Blender at the moment.

Waiting for my Solidoodle, I have started to change some of my models so they are more solid and be printable.

Would I have much trouble with printing something like my little Kendo char?