<![CDATA[SoliForum - 3D Printing Community — Tips for lower infill]]> https://www.soliforum.com/topic/4718/tips-for-lower-infill/ Sun, 01 Dec 2013 22:10:48 +0000 PunBB <![CDATA[Re: Tips for lower infill]]> https://www.soliforum.com/post/43003/#p43003 You might also adjust your speed/flow settings for bridging as you might get less droop however some of this is temperature dependent so if you can drop the temps a bit it may help... or a fan on the extruder.

Here is a vid of some extreme bridging--> https://www.youtube.com/watch?v=_b6hFFcLh_Q if you can get even close to his settings you should have nothing to worry about smile

]]> Sun, 01 Dec 2013 22:10:48 +0000 https://www.soliforum.com/post/43003/#p43003 <![CDATA[Re: Tips for lower infill]]> https://www.soliforum.com/post/42997/#p42997 Go with rectilinear, at least try it. I use it cause it's faster.

]]> Sun, 01 Dec 2013 21:55:20 +0000 https://www.soliforum.com/post/42997/#p42997 <![CDATA[Tips for lower infill]]> https://www.soliforum.com/post/42995/#p42995 Hey guys I was wondering if you guys would share your tips for printing with lower infill.  It seems I get drooping of the layers as it tries to span the gaps left from a .1 honeycomb infill.  Thanks for any info you can provide. I'm a newb lol :-)

]]> Sun, 01 Dec 2013 21:42:54 +0000 https://www.soliforum.com/post/42995/#p42995