<![CDATA[SoliForum - 3D Printing Community — Bed shaking]]> https://www.soliforum.com/topic/4709/bed-shaking/ Sat, 30 Nov 2013 10:48:43 +0000 PunBB <![CDATA[Re: Bed shaking]]> https://www.soliforum.com/post/42903/#p42903 Excellent I'll try both of these when I get home. Big domo!!

]]> Sat, 30 Nov 2013 10:48:43 +0000 https://www.soliforum.com/post/42903/#p42903 <![CDATA[Re: Bed shaking]]> https://www.soliforum.com/post/42897/#p42897 also if your extruder is over-extruding it will exert more lateral forces on the bed vertical support rods when printing in the front areas.

In case you have not done the extruder calibrations here are some links:
http://www.soliwiki.com/Main_Page#Calibrations

http://www.youtube.com/watch?v=JZGdMc2ebPo

]]> Sat, 30 Nov 2013 06:51:47 +0000 https://www.soliforum.com/post/42897/#p42897 <![CDATA[Re: Bed shaking]]> https://www.soliforum.com/post/42892/#p42892 try lowering all you adjustment screws and then re set the z-height having them as low as possible, add a little smidgen and relevel the bed. - its easy to creep upwards constantly on them and end up with a lot of unsupported screw...

]]> Sat, 30 Nov 2013 05:51:09 +0000 https://www.soliforum.com/post/42892/#p42892 <![CDATA[Bed shaking]]> https://www.soliforum.com/post/42889/#p42889 Hey guys quick question, I'm not sure where to start with trouble shooting.  What would cause the bed to shack during printing. It doesn't happen when the nozzle is towards the "back" of the bed, but when it's moves towards the front it begins to shake.  Thanks for any input :-)

]]> Sat, 30 Nov 2013 05:40:56 +0000 https://www.soliforum.com/post/42889/#p42889