SoliForum - 3D Printing Community — Bad Cold Jam/Clog

Re: Bad Cold Jam/Clog

null@example.com (keith09) — Sun, 17 Nov 2013 20:11:08 +0000

took about an hour but a 1/16 extended pilot bit was able to drill through. Along with a little scrapping with a metal wire I was able to clear it all out. deff won't be leaving my printer on its own for a while

Re: Bad Cold Jam/Clog

null@example.com (3d-oodler) — Sun, 17 Nov 2013 01:46:40 +0000

I had a similar clog and ended up taking the acrylic apart to clear it.

Bad Cold Jam/Clog

null@example.com (keith09) — Sat, 16 Nov 2013 21:53:32 +0000

Left the room for an hour during a 7 hour print and came back to this....(image attached)

Tried pushing with a hex tool but its expanded really good into little balls in the acrylic. I am guessing my only option is to take the thing apart. The extruder itself is not clogged because when i heat it up i am getting some filament or at least was getting whatever was left in the nose. I was also thinking about getting a long fine drill bit, but i don't know how far down the clog goes.