<![CDATA[SoliForum - 3D Printing Community — Out of the box and in verification of full function - Pre calibration]]> https://www.soliforum.com/topic/4522/out-of-the-box-and-in-verification-of-full-function-pre-calibration/ Mon, 11 Nov 2013 23:59:19 +0000 PunBB <![CDATA[Re: Out of the box and in verification of full function - Pre calibration]]> https://www.soliforum.com/post/41390/#p41390 @ 3D-oodler:
Fully solved.
(Mea culpa).   Machine was not homed before starting to check it out.

Thank you.

James.

]]> Mon, 11 Nov 2013 23:59:19 +0000 https://www.soliforum.com/post/41390/#p41390 <![CDATA[Re: Out of the box and in verification of full function - Pre calibration]]> https://www.soliforum.com/post/41385/#p41385 Home all axes first to see if this solves the problem. (home buttons in Repeatier Host)

]]> Mon, 11 Nov 2013 23:05:35 +0000 https://www.soliforum.com/post/41385/#p41385 <![CDATA[Out of the box and in verification of full function - Pre calibration]]> https://www.soliforum.com/post/41384/#p41384 Hello.
X axis is funky.
- I found the message about switching the Y and the X axis, to test if the X axis is getting commands.
   - - The X axis is getting commands.
- So I put the X and Y axese back the way they were.
- I then test the X axis again, and it starts to work.  (So I disturbed some insulating oxides? maybe).
-
- When the extruderr head is 10 cm away from the frame, headed toward the other side,
   - - It stops.
      - - - Backing it off a mm works.
        - - - - Going toward the other side by 1/10 of a millimeter stops again, about where it stopped before.
                  So the movement action stops where it stopped before.

Is there another debugging/maint message I can read that explains the action and cure?

James.

]]> Mon, 11 Nov 2013 22:46:52 +0000 https://www.soliforum.com/post/41384/#p41384