<![CDATA[SoliForum - 3D Printing Community — Question about print quality]]> https://www.soliforum.com/topic/4481/question-about-print-quality/ Fri, 08 Nov 2013 00:50:19 +0000 PunBB <![CDATA[Re: Question about print quality]]> https://www.soliforum.com/post/40971/#p40971 Thanks guys. It was set at 195c but that is a great suggestion about printing multiple things so it cools.

]]> Fri, 08 Nov 2013 00:50:19 +0000 https://www.soliforum.com/post/40971/#p40971 <![CDATA[Re: Question about print quality]]> https://www.soliforum.com/post/40960/#p40960 The easiest way to fix that is to print something else at the same time to give the small areas time to cool.  It could just be a column that you will throw away if you don't have something else you want to print, that is tall enough.

]]> Fri, 08 Nov 2013 00:12:31 +0000 https://www.soliforum.com/post/40960/#p40960 <![CDATA[Re: Question about print quality]]> https://www.soliforum.com/post/40957/#p40957 Heat.

Lower layers take more time, so plenty of time to cool.

]]> Thu, 07 Nov 2013 23:42:52 +0000 https://www.soliforum.com/post/40957/#p40957 <![CDATA[Question about print quality]]> https://www.soliforum.com/post/40955/#p40955 Hey everyone,

I have read and done a bunch of recommendations in regards to cleaning the print bed, leveling, etc. I still have some issues getting the first layer to stick. To be honest it is hit or miss. Sometimes it is flawless, sometimes not so much. Im not sure if it is common but every print is different.

I did this cube a few minutes ago and it started fine but at the top it bunched up. What causes this?

]]> Thu, 07 Nov 2013 23:36:08 +0000 https://www.soliforum.com/post/40955/#p40955