<![CDATA[SoliForum - 3D Printing Community — QU BD]]> https://www.soliforum.com/topic/4268/qu-bd/ Sun, 27 Oct 2013 20:44:29 +0000 PunBB <![CDATA[Re: QU BD]]> https://www.soliforum.com/post/40078/#p40078 would  a 300 watt  atx psu  rated at 12v@15a do the job?

]]> Sun, 27 Oct 2013 20:44:29 +0000 https://www.soliforum.com/post/40078/#p40078 <![CDATA[Re: QU BD]]> https://www.soliforum.com/post/40057/#p40057 In case you (or future readers) have a printrboard, the supply trace is big enough and the gate driver can handle 100 Amps.

But again, the limiting factor is the power supply only putting out 12.5 Amps total for the entire printer. The Qu-bd heater takes 11.5 Amps.

]]> Sun, 27 Oct 2013 15:45:03 +0000 https://www.soliforum.com/post/40057/#p40057 <![CDATA[Re: QU BD]]> https://www.soliforum.com/post/40050/#p40050 Works with sanguinololu but you have to wire it differently and have the right sized power supply.  I believe I had the negative wired to the hole in the MOSFET to compensate for the small traces on that board.

]]> Sun, 27 Oct 2013 12:39:57 +0000 https://www.soliforum.com/post/40050/#p40050 <![CDATA[Re: QU BD]]> https://www.soliforum.com/post/39174/#p39174 Ok thanks, will do

]]> Thu, 17 Oct 2013 07:06:50 +0000 https://www.soliforum.com/post/39174/#p39174 <![CDATA[Re: QU BD]]> https://www.soliforum.com/post/39171/#p39171 no or not recommended, and the power supply definitely wont

Theres plenty of threads covering this one already, so have a search around for the details - the solutions depend entirely on which controller board you have (depends when your SD shipped).

]]> Thu, 17 Oct 2013 07:02:04 +0000 https://www.soliforum.com/post/39171/#p39171 <![CDATA[QU BD]]> https://www.soliforum.com/post/39167/#p39167 Will the printer main board handle the current draw of the QU BD silicone heat bed?

]]> Thu, 17 Oct 2013 05:22:22 +0000 https://www.soliforum.com/post/39167/#p39167