<![CDATA[SoliForum - 3D Printing Community — Solidoodle Nozzle question]]> https://www.soliforum.com/topic/4198/solidoodle-nozzle-question/ Thu, 10 Oct 2013 22:36:18 +0000 PunBB <![CDATA[Re: Solidoodle Nozzle question]]> https://www.soliforum.com/post/38632/#p38632 Thanks Ian!

]]> Thu, 10 Oct 2013 22:36:18 +0000 https://www.soliforum.com/post/38632/#p38632 <![CDATA[Re: Solidoodle Nozzle question]]> https://www.soliforum.com/post/38631/#p38631 The nozzles at Makergear.com are compatible, and they have a .5.  http://www.makergear.com/products/nozzles

]]> Thu, 10 Oct 2013 22:33:41 +0000 https://www.soliforum.com/post/38631/#p38631 <![CDATA[Re: Solidoodle Nozzle question]]> https://www.soliforum.com/post/38629/#p38629 Do you offer nozzles in larger bores than .40mm ? On your site I could only see one size listed. I'd probably be willing to buy a complete hot-end if I could get a different nozzle on it.

]]> Thu, 10 Oct 2013 21:54:38 +0000 https://www.soliforum.com/post/38629/#p38629 <![CDATA[Re: Solidoodle Nozzle question]]> https://www.soliforum.com/post/38628/#p38628 You'll have to redo some slic3r settings at the very least. Can't say I've tried a replicator nozzle myself. It may not be compatible with the threading of our brass barrel.

]]> Thu, 10 Oct 2013 21:51:34 +0000 https://www.soliforum.com/post/38628/#p38628 <![CDATA[Solidoodle Nozzle question]]> https://www.soliforum.com/post/38626/#p38626 I've been offered a nozzle with a larger bore, but it's from a Replicator 2 I believe. Is the nozzle interchangeable/compatible?

The wiki makes it look a bit of a pain to swap over? Thoughts on this?

The reason I'm doing it to enable less clog prone printing of filaments such as Laywood.

]]> Thu, 10 Oct 2013 21:47:22 +0000 https://www.soliforum.com/post/38626/#p38626