<![CDATA[SoliForum - 3D Printing Community — Nylon 645 Issue]]> https://www.soliforum.com/topic/3901/nylon-645-issue/ Wed, 02 Oct 2013 16:42:22 +0000 PunBB <![CDATA[Re: Nylon 645 Issue]]> https://www.soliforum.com/post/37917/#p37917 Slow down. I found that with nylon and tglase I am running almost half speed or i get jams like that.

]]> Wed, 02 Oct 2013 16:42:22 +0000 https://www.soliforum.com/post/37917/#p37917 <![CDATA[Re: Nylon 645 Issue]]> https://www.soliforum.com/post/36172/#p36172 have you tried lowering the extrusion acceleration speed for the stepper?

]]> Fri, 13 Sep 2013 04:26:48 +0000 https://www.soliforum.com/post/36172/#p36172 <![CDATA[Re: Nylon 645 Issue]]> https://www.soliforum.com/post/36138/#p36138 I wonder if someone could do a mod with brass tube cut like a /\ to fit right near the cog and bearing, to prevent that.

]]> Thu, 12 Sep 2013 23:49:09 +0000 https://www.soliforum.com/post/36138/#p36138 <![CDATA[Nylon 645 Issue]]> https://www.soliforum.com/post/36122/#p36122 Any suggestions on this jamming issue with Nylon 645? I had a similar issue with T-Glass in the beginning, but that was due to irregular shape. This 645 is a bit oval shaped, but nothing compared to section of T-Glass I had an issue with.

I've tried adjusting the layer height, extrusion width, print temperature, platform height, and print speed with no luck. I am able to feed through filament manually without an issue. I fed 100mm through while checking extruder multiplier without a problem. I have an E3D hotend so I don't suspect the filament is warming, but 645 filament is quite flexible.

Any suggestions?  neutral

http://i.imgur.com/oHryXqp.jpg

]]> Thu, 12 Sep 2013 21:48:47 +0000 https://www.soliforum.com/post/36122/#p36122