<![CDATA[SoliForum - 3D Printing Community — printBIG - not woriking 4 me...]]> https://www.soliforum.com/topic/3793/printbig-not-woriking-4-me/ Wed, 04 Sep 2013 16:50:44 +0000 PunBB <![CDATA[Re: printBIG - not woriking 4 me...]]> https://www.soliforum.com/post/35170/#p35170 hey - thanks for the hint!
this really look pretty much the same problem....

enclosure promising

]]> Wed, 04 Sep 2013 16:50:44 +0000 https://www.soliforum.com/post/35170/#p35170 <![CDATA[Re: printBIG - not woriking 4 me...]]> https://www.soliforum.com/post/35165/#p35165 Are you using an enclosure?

Your temps for black from solidoodle should be around 205 to 210 which is aka (235- 240 actually temp is 30 degrees higher)
I had issues similar to yours however when I increased the temperature the layers were sticking properly.

If you want to print big parts in abs you need an enclosure.

See this article

http://diy3dprinting.blogspot.com/2013/ … print.html

]]> Wed, 04 Sep 2013 15:53:05 +0000 https://www.soliforum.com/post/35165/#p35165 <![CDATA[printBIG - not woriking 4 me...]]> https://www.soliforum.com/post/35152/#p35152 hey,
after a few weeks of "trail and error" i figured out how to get good results out of my solidoodle3 printer.
but…  only in tiny prints…
I tried to print a bigger part (ca. 15cm x 15cm x 15cm) with absolutely no luck… [pictures]

because of the abs tension the layers begin to bent…
I tried a lower extruder temperature – about 190 C
I was thinking:  lower temp -> less temp difference -> less tension…
the result was fail.jpg

how can this be done?
can I only print thin and high by changing to pla? or can't this be done anyway?

peet

]]> Wed, 04 Sep 2013 14:50:04 +0000 https://www.soliforum.com/post/35152/#p35152