<![CDATA[SoliForum - 3D Printing Community — can someone explain this slice?]]> https://www.soliforum.com/topic/3754/can-someone-explain-this-slice/ Sun, 01 Sep 2013 16:30:25 +0000 PunBB <![CDATA[Re: can someone explain this slice?]]> https://www.soliforum.com/post/34873/#p34873 2n2r5 wrote:

That gap isn't big enough for slicer to fit another pass. If you back off your perimeters to 2 the infill should take over and fill that gap for you.

that did it.  had my parameters set to 4 from another print.  I was able to get it to fill in at 3.  Thanks!

]]> Sun, 01 Sep 2013 16:30:25 +0000 https://www.soliforum.com/post/34873/#p34873 <![CDATA[Re: can someone explain this slice?]]> https://www.soliforum.com/post/34871/#p34871 That gap isn't big enough for slicer to fit another pass. If you back off your perimeters to 2 the infill should take over and fill that gap for you.

]]> Sun, 01 Sep 2013 16:21:16 +0000 https://www.soliforum.com/post/34871/#p34871 <![CDATA[can someone explain this slice?]]> https://www.soliforum.com/post/34870/#p34870 I just upgraded to the new RH and was checking the settings so i did a slice of a part i have already printed.  It could have been the other version of slic3r did the same thing i just didn't notice it.  Anyway, could someone explain why the top and bottom layers are not creating a bottom/top in the area around the radius?

]]> Sun, 01 Sep 2013 16:02:57 +0000 https://www.soliforum.com/post/34870/#p34870