<![CDATA[SoliForum - 3D Printing Community — Items print too large]]> https://www.soliforum.com/topic/3711/items-print-too-large/ Thu, 29 Aug 2013 10:43:09 +0000 PunBB <![CDATA[Re: Items print too large]]> https://www.soliforum.com/post/34537/#p34537 and now it's just about calibrating your flow and filament smile Welcome to the light side.

]]> Thu, 29 Aug 2013 10:43:09 +0000 https://www.soliforum.com/post/34537/#p34537 <![CDATA[Re: Items print too large]]> https://www.soliforum.com/post/34527/#p34527 What kind of powerful dark magic is this? I switched to Slic3r and it printed the .5mm walls at .63mm, much much closer to what it should be.

]]> Thu, 29 Aug 2013 06:36:50 +0000 https://www.soliforum.com/post/34527/#p34527 <![CDATA[Re: Items print too large]]> https://www.soliforum.com/post/34506/#p34506 Stop using Skeinforge for starters. smile

Then it will be easier to check your settings.

]]> Thu, 29 Aug 2013 03:08:51 +0000 https://www.soliforum.com/post/34506/#p34506 <![CDATA[Items print too large]]> https://www.soliforum.com/post/34504/#p34504 Nothing comically large, just not even in the ballpark of what the item should be. I downloaded a calibration cube from thingiverse with walls that are supposed to be .5mm thick. What gets spit out is the correct height but the walls are at 1.40mm so almost 3 times what its supposed to be.

I just recently started using Repetier Host, but I am still using Skeinforge to slice. Can anyone tell me what settings I should be looking to tweak to fix this?

]]> Thu, 29 Aug 2013 03:03:12 +0000 https://www.soliforum.com/post/34504/#p34504