<![CDATA[SoliForum - 3D Printing Community — Library of Photos.]]> https://www.soliforum.com/topic/3659/library-of-photos/ Tue, 17 Sep 2013 19:14:04 +0000 PunBB <![CDATA[Re: Library of Photos.]]> https://www.soliforum.com/post/36625/#p36625 Thanks Ian. I feel better now!

]]> Tue, 17 Sep 2013 19:14:04 +0000 https://www.soliforum.com/post/36625/#p36625 <![CDATA[Re: Library of Photos.]]> https://www.soliforum.com/post/36590/#p36590 This isn't as organized, but it's interesting - http://www.flickr.com/groups/3d-print-failures/

As print failures go, this one is pretty scary-

http://farm9.staticflickr.com/8388/8472258810_a336500719.jpg

]]> Tue, 17 Sep 2013 05:12:07 +0000 https://www.soliforum.com/post/36590/#p36590 <![CDATA[Re: Library of Photos.]]> https://www.soliforum.com/post/36585/#p36585 I think more amateur photos would be better. These photos are only one example and I am not sure they are as clear as they could be.

]]> Tue, 17 Sep 2013 04:18:04 +0000 https://www.soliforum.com/post/36585/#p36585 <![CDATA[Re: Library of Photos.]]> https://www.soliforum.com/post/34152/#p34152 You mean like this ?

http://reprap.org/wiki/Print_Troublesho … de#CAUSES:

]]> Sat, 24 Aug 2013 06:31:31 +0000 https://www.soliforum.com/post/34152/#p34152 <![CDATA[Library of Photos.]]> https://www.soliforum.com/post/34144/#p34144 So everyone knows what different things should likely look like. If the bed is too high or low at the start of printing, if it is not leveled from the corners, if the plastic coming through is intermittent, if it is too hot, cold, or whatever. When the free wheel arm is too tight versus too loose, etc. I think it would be good to see many, many photos taken by different people of virtually the same issues to confirm ones understanding of what their particular issue might end up being.

]]> Sat, 24 Aug 2013 02:54:00 +0000 https://www.soliforum.com/post/34144/#p34144