<![CDATA[SoliForum - 3D Printing Community — Ben Franklin bust]]> https://www.soliforum.com/topic/3552/ben-franklin-bust/ Tue, 05 Nov 2013 08:13:01 +0000 PunBB <![CDATA[Re: Ben Franklin bust]]> https://www.soliforum.com/post/40757/#p40757 +1 for the presto parts finisher!

]]> Tue, 05 Nov 2013 08:13:01 +0000 https://www.soliforum.com/post/40757/#p40757 <![CDATA[Re: Ben Franklin bust]]> https://www.soliforum.com/post/40668/#p40668 Can you purge them in water to stop the acetone from eating the plastic between exposures?

]]> Mon, 04 Nov 2013 08:45:00 +0000 https://www.soliforum.com/post/40668/#p40668 <![CDATA[Re: Ben Franklin bust]]> https://www.soliforum.com/post/33068/#p33068 I've seen Ian's method.  It is on my list of things to get.  Just wanted to see if you were doing something similar, or using a different method.  Your print came out awesome.

]]> Thu, 15 Aug 2013 14:53:12 +0000 https://www.soliforum.com/post/33068/#p33068 <![CDATA[Re: Ben Franklin bust]]> https://www.soliforum.com/post/32973/#p32973 Thanks,I use a Presto Kitchen Kettle 

http://www.amazon.com/Presto-06006-Kitc … hen+kettle

I learned about it from Ian's blog: http://solidoodletips.wordpress.com/201 … -finisher/

At .1mm there was very little layering,it only took 20secs in the vapor bath to get that result.You can get close to the same at .3 layers but it's best to do multiple exposures at 20-30 sec at a time.

]]> Wed, 14 Aug 2013 22:31:01 +0000 https://www.soliforum.com/post/32973/#p32973 <![CDATA[Re: Ben Franklin bust]]> https://www.soliforum.com/post/32957/#p32957 Looks awesome.  Couldn't see any layering in that photo.  Very professional results.  What equipment are you using for your vapor bath?

]]> Wed, 14 Aug 2013 20:39:48 +0000 https://www.soliforum.com/post/32957/#p32957 <![CDATA[Ben Franklin bust]]> https://www.soliforum.com/post/32951/#p32951 Sd2 at .1mm
Acetone vapor bath
Finished with Rustoleum "Oil Rubbed Bronze" spray  paint.

]]> Wed, 14 Aug 2013 19:51:59 +0000 https://www.soliforum.com/post/32951/#p32951