<![CDATA[SoliForum - 3D Printing Community — Thingiverse - Solidoodle 3 Filament Feed Guide]]> https://www.soliforum.com/topic/3514/thingiverse-solidoodle-3-filament-feed-guide/ Sat, 17 Aug 2013 13:51:59 +0000 PunBB <![CDATA[Re: Thingiverse - Solidoodle 3 Filament Feed Guide]]> https://www.soliforum.com/post/33304/#p33304 Yep, it was a little hard to swing it into place but once in place it holds solid as a rock.  Actually, that's orange, but the flash on my iPhone makes it look a bit yellow -- compare the orange on the filament spool behind it to the orange of the same filament as it's coming through and you'll see what I mean.

I printed it without supports and had to trim a little bit, but that's only because the curve goes a little past the semicircle, so there's a little bit that's printing with nothing to stand on.  I think if you'd put in a support just to that point -- or ended at the semicircle -- it would have been free of that.  It can print a pretty steep curve as long as it's not a negative curve.  But, as you said in the instructions, the little bit you have to trim doesn't impede form or function at all, so it's fine to leave it as is.

]]> Sat, 17 Aug 2013 13:51:59 +0000 https://www.soliforum.com/post/33304/#p33304 <![CDATA[Re: Thingiverse - Solidoodle 3 Filament Feed Guide]]> https://www.soliforum.com/post/33293/#p33293 Wow, that lloks great in yellow smile  I'm pretty chuffed to see something I designed in use. Did it all fit nicely for you?

]]> Sat, 17 Aug 2013 07:19:25 +0000 https://www.soliforum.com/post/33293/#p33293 <![CDATA[Re: Thingiverse - Solidoodle 3 Filament Feed Guide]]> https://www.soliforum.com/post/33206/#p33206 http://thingiverse-production.s3.amazonaws.com/renders/95/86/d6/69/db/1185175_704826232865058_705467505_n_preview_featured.jpg

]]> Fri, 16 Aug 2013 15:21:25 +0000 https://www.soliforum.com/post/33206/#p33206 <![CDATA[Re: Thingiverse - Solidoodle 3 Filament Feed Guide]]> https://www.soliforum.com/post/32566/#p32566 Nice design.

]]> Sun, 11 Aug 2013 12:59:01 +0000 https://www.soliforum.com/post/32566/#p32566 <![CDATA[Thingiverse - Solidoodle 3 Filament Feed Guide]]> https://www.soliforum.com/post/32553/#p32553 After a few tangles and filament messes I decided to print one of the guides from Thingiverse, but the one I found was very loose and came off easily.

So here is my remix, a ground up rebuild designed specifically to lock onto the SD 3 with a nice tight fit. (may also work on an SD2)

Feedback welcome!

http://www.thingiverse.com/thing:130168

]]> Sun, 11 Aug 2013 06:16:47 +0000 https://www.soliforum.com/post/32553/#p32553