<![CDATA[SoliForum - 3D Printing Community — repetier host slicer]]> https://www.soliforum.com/topic/3410/repetier-host-slicer/ Sat, 03 Aug 2013 11:15:54 +0000 PunBB <![CDATA[Re: repetier host slicer]]> https://www.soliforum.com/post/31775/#p31775 Joecool509 wrote:

I used the ones provided with the solidoodle instructions then did a full calibration and it made a huge difference. you have to save each tab separately when you load the preconfigured file. Good luck. Pics would help diagnose any problems as well.


Joe is correct.  when my SD3 arrived, I did a Z axis set then did a print.  Then started with the calibrations.  My prints are as good now as the Stratasys printer that I was using before (work printer).

]]> Sat, 03 Aug 2013 11:15:54 +0000 https://www.soliforum.com/post/31775/#p31775 <![CDATA[Re: repetier host slicer]]> https://www.soliforum.com/post/31761/#p31761 I used the ones provided with the solidoodle instructions then did a full calibration and it made a huge difference. you have to save each tab separately when you load the preconfigured file. Good luck. Pics would help diagnose any problems as well.

]]> Sat, 03 Aug 2013 02:01:00 +0000 https://www.soliforum.com/post/31761/#p31761 <![CDATA[repetier host slicer]]> https://www.soliforum.com/post/31760/#p31760 I am working with a solidoodle 3 and repetier host. for those of you who are doing the same what are some good configurations for the slicer. my prints just dont come out looking very good. any help would be great thanks.

]]> Sat, 03 Aug 2013 01:56:38 +0000 https://www.soliforum.com/post/31760/#p31760