https://www.soliforum.com/topic/3381/prusa-mendel-xaxis-slipping/ Wed, 31 Jul 2013 19:10:08 +0000 PunBB https://www.soliforum.com/post/31551/#p31551 Thank you for your response. I ended up tightening the belt and it works fine now.

]]> Wed, 31 Jul 2013 19:10:08 +0000 https://www.soliforum.com/post/31551/#p31551 https://www.soliforum.com/post/31547/#p31547 Sounds like belt tension or overheat of the stepper.  Check both of these.

]]> Wed, 31 Jul 2013 18:49:01 +0000 https://www.soliforum.com/post/31547/#p31547 https://www.soliforum.com/post/31535/#p31535 Hello, I'm currently trying to print a calibration cube with my prusa mendel V1 and after it completes a couple of layers the Extruder will slide quickly to the right and continue to layer but this time starting in the middle of the cube and layering the other half on top of the bed. This will continue to happen if I let it to continue to print where I'll have 4 base layers of cubes overlapping each other starting in the middle. Any assistance would be greatly appreciated, Thank you!

]]> Wed, 31 Jul 2013 17:43:06 +0000 https://www.soliforum.com/post/31535/#p31535