<![CDATA[SoliForum - 3D Printing Community — Speeds in Slic3r]]> https://www.soliforum.com/topic/320/speeds-in-slic3r/ Wed, 17 Oct 2012 20:10:11 +0000 PunBB <![CDATA[Re: Speeds in Slic3r]]> https://www.soliforum.com/post/2426/#p2426 There has been a lot of talk about speed lately. Perhaps someone can come up with a profile optimized for fast prints?

]]> Wed, 17 Oct 2012 20:10:11 +0000 https://www.soliforum.com/post/2426/#p2426 <![CDATA[Re: Speeds in Slic3r]]> https://www.soliforum.com/post/2405/#p2405 The obvious thing is the travel speed, bump it up to 150mm/s.

You can probably bump up the infill a bit as well, at least 60mm/s.

]]> Wed, 17 Oct 2012 11:29:10 +0000 https://www.soliforum.com/post/2405/#p2405 <![CDATA[Speeds in Slic3r]]> https://www.soliforum.com/post/2402/#p2402 I finally upgraded my firmware from the original sprinter to Marlin from Lawsy's update because I wanted to use Slic3r and Repetier Host. I noticed that the printer is slower using the slic3r configuration than Skeinforge. What print speeds are being used successfully in the print settings in Slic3r? I followed Ian's great walkthrough and I either missed this setting or it wasn't mentioned. I know from some of the posts that others are successfully printing at higher speeds than the defaults.

]]> Wed, 17 Oct 2012 10:46:23 +0000 https://www.soliforum.com/post/2402/#p2402