<![CDATA[SoliForum - 3D Printing Community — Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/topic/3179/chei-mei-pa747-anyone-used-it/ Tue, 16 Jul 2013 09:39:04 +0000 PunBB <![CDATA[Re: Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/post/29985/#p29985 Hello Craig,
I have noticed a few on this forum, and on youtube.
I dont think theres enough users in the UK (whilst Im British, I dont live there at the mo) to order a ton of them in and divide it up

]]> Tue, 16 Jul 2013 09:39:04 +0000 https://www.soliforum.com/post/29985/#p29985 <![CDATA[Re: Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/post/29978/#p29978 reesy wrote:

Thanks for the comments Ian, I have noticed a few people in the UK using it.
Any other experiences any one?

Hi Reesy,  anyone in particular in the UK?

I'm looking for other UK Filastruder owners to try to co-ordinate efforts to get decent pellets.

Craig

]]> Tue, 16 Jul 2013 06:39:03 +0000 https://www.soliforum.com/post/29978/#p29978 <![CDATA[Re: Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/post/29974/#p29974 Thanks Tim, theres a photo on this board of someone using it (theres a big sack of it next to the Filastruder).
If anyone else out there has any comments, they would be appreciated.

]]> Tue, 16 Jul 2013 05:53:49 +0000 https://www.soliforum.com/post/29974/#p29974 <![CDATA[Re: Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/post/29966/#p29966 I'll echo Ian. I haven't run it through a Filastruder, but no reason it shouldn't work fine. My research has shown its a very popular flavor of resin to use in 3D Printing.

]]> Tue, 16 Jul 2013 04:09:02 +0000 https://www.soliforum.com/post/29966/#p29966 <![CDATA[Re: Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/post/29964/#p29964 Thanks for the comments Ian, I have noticed a few people in the UK using it.
Any other experiences any one?

]]> Tue, 16 Jul 2013 03:47:26 +0000 https://www.soliforum.com/post/29964/#p29964 <![CDATA[Re: Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/post/29913/#p29913 I haven't run across it in pellets, but most ABS filament you buy from commercial 3D Printer suppliers will be PA747.  MG94 is a more premium plastic, and is what Stratasys uses for their ABS.

]]> Mon, 15 Jul 2013 16:32:52 +0000 https://www.soliforum.com/post/29913/#p29913 <![CDATA[Chei Mei PA747 - Anyone used it?]]> https://www.soliforum.com/post/29905/#p29905 Any experience, comments good or bad about the above anyone?
Thanks

]]> Mon, 15 Jul 2013 14:30:30 +0000 https://www.soliforum.com/post/29905/#p29905