SoliForum - 3D Printing Community — Octave gray abs

Re: Octave gray abs

null@example.com (nlancaster) — Mon, 08 Jul 2013 02:38:25 +0000

yes they have awesome customer service.

Re: Octave gray abs

null@example.com (nemesis200) — Sun, 07 Jul 2013 18:55:23 +0000

thanks All. I contacted octave and they are refunding me for the roll.

Re: Octave gray abs

null@example.com (RavensCrest) — Fri, 05 Jul 2013 16:26:18 +0000

I ran into this kind of problem also... so i changed the feeding direction. instead of feeding filament from the hole in the back. i printed http://www.thingiverse.com/thing:97734 spool holder, and feed filament thru top.
hope you don't have a cover on top. :-(

Re: Octave gray abs

null@example.com (dkeeling728) — Fri, 05 Jul 2013 14:06:10 +0000

i had it happen once on a roll of octave white. popped the roll in the oven at 170f for 5 minutes, and haven't had another problem with it. parts come out strong as any of my other ABS. so i think its not so much bad material as it was bad extrusion in manufacturing.

one thing im working on is a part to bolt on to the mk4/5 extruder by lawsy that integrates a small coil spring as a strain relief. just trying to find a universal source for a coil spring so that anyone can make one without having to modify the design or special order a specific spring. this would mostly eliminate the threat of snapped filament in the first place.

Re: Octave gray abs

null@example.com (Krythis) — Thu, 04 Jul 2013 18:18:14 +0000

I had this happen with the blue filament in a rainbow spool I picked up recently. Thankfully it only happened once, hope the rest is good.

Re: Octave gray abs

null@example.com (nlancaster) — Thu, 04 Jul 2013 07:47:53 +0000

Nemesis, this is a known problem. Email octave customer service, you have a bad roll of filament. They should be more then willing to replace it. Apparently a shipment of several thousand rolls was not the correct material and they have been replacing filament left and right because of it. They only managed to recall about 60-70% before it was sold.

Octave gray abs

null@example.com (nemesis200) — Thu, 04 Jul 2013 04:44:14 +0000

I purchased a roll of this and every time i try to print i get about halfway through the pring and the filiment just snaps in two about a centermeter above where it enters the extuder. has any on had this issue and any resolution. this is on a solidoodle 3