<![CDATA[SoliForum - 3D Printing Community — No: 82]]> https://www.soliforum.com/topic/3014/no-82/ Mon, 01 Jul 2013 06:49:11 +0000 PunBB <![CDATA[Re: No: 82]]> https://www.soliforum.com/post/28600/#p28600 AH I see smile
Looks good!

]]> Mon, 01 Jul 2013 06:49:11 +0000 https://www.soliforum.com/post/28600/#p28600 <![CDATA[Re: No: 82]]> https://www.soliforum.com/post/28596/#p28596 They're' feet (3 points creates a plane) it should sit flat on most uneven surfaces.

reesy wrote:

Interesting, is that meant to hang off the end of the table or perhaps be extruding downwards at an angle?
I refer to the bulbous part bottom right of the case.

]]> Mon, 01 Jul 2013 05:39:52 +0000 https://www.soliforum.com/post/28596/#p28596 <![CDATA[Re: No: 82]]> https://www.soliforum.com/post/28594/#p28594 Interesting, is that meant to hang off the end of the table or perhaps be extruding downwards at an angle?
I refer to the bulbous part bottom right of the case.

]]> Mon, 01 Jul 2013 05:05:27 +0000 https://www.soliforum.com/post/28594/#p28594 <![CDATA[Re: No: 82]]> https://www.soliforum.com/post/28572/#p28572 The hopper has changed and the fitment is much better (no gap).

]]> Mon, 01 Jul 2013 02:53:31 +0000 https://www.soliforum.com/post/28572/#p28572 <![CDATA[Re: No: 82]]> https://www.soliforum.com/post/28570/#p28570 Aren't the pellets going to spill out the bottom of the hopper?  Or is there another part that isn't on there yet?

]]> Mon, 01 Jul 2013 02:49:11 +0000 https://www.soliforum.com/post/28570/#p28570 <![CDATA[No: 82]]> https://www.soliforum.com/post/28567/#p28567 Just about ready to extrude.............

]]> Mon, 01 Jul 2013 02:17:32 +0000 https://www.soliforum.com/post/28567/#p28567