<![CDATA[SoliForum - 3D Printing Community — Support settings for easy removal]]> https://www.soliforum.com/topic/2849/support-settings-for-easy-removal/ Tue, 18 Jun 2013 03:44:35 +0000 PunBB <![CDATA[Re: Support settings for easy removal]]> https://www.soliforum.com/post/26780/#p26780 Search Youtube.  A poster here  (Ian Johnson) has some suggestions on the settings for the software.

]]> Tue, 18 Jun 2013 03:44:35 +0000 https://www.soliforum.com/post/26780/#p26780 <![CDATA[Re: Support settings for easy removal]]> https://www.soliforum.com/post/26777/#p26777 I was going to try kissslicer, but since I have been "working" from my machine, I don't have time to tweak things right now. I will be giving it a try when things calm down next week though.

]]> Tue, 18 Jun 2013 03:35:46 +0000 https://www.soliforum.com/post/26777/#p26777 <![CDATA[Re: Support settings for easy removal]]> https://www.soliforum.com/post/26749/#p26749 Support in slic3r has not been my friend. Other slicers like Kisslicer and skein forge are much better handling support in my opinion.

]]> Tue, 18 Jun 2013 00:48:37 +0000 https://www.soliforum.com/post/26749/#p26749 <![CDATA[Support settings for easy removal]]> https://www.soliforum.com/post/26746/#p26746 Greetings all,

I have been doing a lot of printing on my SD2 lately for my job(yay!). I was wondering of there were any firmware or setting tweaks in Slic3r to make support material easy to remove. Right now, I have the support set to 1.mm spacing, and offset 45 degrees in relation to the part. It's not too bad to remove now, but I am always looking for a way to make my life a little easier. : )

Thanks!

]]> Tue, 18 Jun 2013 00:33:58 +0000 https://www.soliforum.com/post/26746/#p26746