<![CDATA[SoliForum - 3D Printing Community — z-axis stepper motor wont home]]> https://www.soliforum.com/topic/2735/zaxis-stepper-motor-wont-home/ Sun, 09 Jun 2013 13:08:06 +0000 PunBB <![CDATA[Re: z-axis stepper motor wont home]]> https://www.soliforum.com/post/25735/#p25735 fixed...

turns out I had to reduce the Z-Axis feedrate from 5mm/sec to 2.5mm/sec...
all appears to be fine now; thankfully...

I'll try a print now, if any problems occur; I'll update the thread.

]]> Sun, 09 Jun 2013 13:08:06 +0000 https://www.soliforum.com/post/25735/#p25735 <![CDATA[z-axis stepper motor wont home]]> https://www.soliforum.com/post/25728/#p25728 I replaced my stepper motor on the z-axis. I can manually move the table up and down. However, when I home the Z-axis, it siezes up and just makes a noise. I have to hit the emergency stop. To print I manually raise the bed as far as  I can and then run the job and it prints no problem.

stepper motor from qu-bd

http://store.qu-bd.com/product.php?id_product=46

any ideas?

]]> Sun, 09 Jun 2013 10:17:51 +0000 https://www.soliforum.com/post/25728/#p25728