<![CDATA[SoliForum - 3D Printing Community — Week 2 Solidoodle II Print Challenge (spinning top)]]> https://www.soliforum.com/topic/272/week-2-solidoodle-ii-print-challenge-spinning-top/ Wed, 14 Nov 2012 04:27:48 +0000 PunBB <![CDATA[Re: Week 2 Solidoodle II Print Challenge (spinning top)]]> https://www.soliforum.com/post/4549/#p4549 When I try to print this i get a crazy amount of curling on the overlaps and it ends up making horrible noises when the head scrapes over top of the layers. I decided to quit while i was ahead smile

]]> Wed, 14 Nov 2012 04:27:48 +0000 https://www.soliforum.com/post/4549/#p4549 <![CDATA[Re: Week 2 Solidoodle II Print Challenge (spinning top)]]> https://www.soliforum.com/post/2028/#p2028 I printed this at .3mm layer thickness.  I've got 2 spools of red abs and a spool of purple and they all look pink when printed.
http://img239.imagevenue.com/loc58/th_542116702_CIMG1466_122_58lo.JPG

]]> Sat, 06 Oct 2012 17:28:14 +0000 https://www.soliforum.com/post/2028/#p2028 <![CDATA[Week 2 Solidoodle II Print Challenge (spinning top)]]> https://www.soliforum.com/post/2025/#p2025 Hopefully we can still get the specific forum folder setup for this, but here is the week 2 challenge.

http://www.thingiverse.com/thing:31671

http://thingiverse-production.s3.amazonaws.com/renders/37/89/94/39/8d/Spinning_top_V3_simplified_preview_card.jpg

I have had a few gos at this, and it is very difficult to get the eight legs to stay firmly onto the bed until the print is far enough along to join them up.

If you can get this to stick properly, you can probably get most things to stick.

]]> Sat, 06 Oct 2012 03:21:09 +0000 https://www.soliforum.com/post/2025/#p2025