<![CDATA[SoliForum - 3D Printing Community — Snap in axle spool holder.]]> https://www.soliforum.com/topic/2378/snap-in-axle-spool-holder/ Mon, 13 May 2013 15:17:13 +0000 PunBB <![CDATA[Re: Snap in axle spool holder.]]> https://www.soliforum.com/post/22693/#p22693 Was refering to these, you pretty much have to loosen one side to change spools.

http://www.thingiverse.com/thing:39879

]]> Mon, 13 May 2013 15:17:13 +0000 https://www.soliforum.com/post/22693/#p22693 <![CDATA[Re: Snap in axle spool holder.]]> https://www.soliforum.com/post/22667/#p22667 I like the use of the support angles for some load distribution on the uprights...

But I'm curious - What normally needs to be unscrewed ? On the SD3 its a simple slide on/off end-cap.. have I missed something ?

]]> Mon, 13 May 2013 09:30:00 +0000 https://www.soliforum.com/post/22667/#p22667 <![CDATA[Snap in axle spool holder.]]> https://www.soliforum.com/post/22633/#p22633 So posted a new addon to Thingiverse today.  Snap in axle spool holders, no more having to unscrew parts to change spools.

http://www.thingiverse.com/thing:87951

http://pdxmc.com/uploads/SD3/20130512_142534.jpg

]]> Sun, 12 May 2013 22:15:42 +0000 https://www.soliforum.com/post/22633/#p22633