<![CDATA[SoliForum - 3D Printing Community — Quantum Delta printer build]]> https://www.soliforum.com/topic/2363/quantum-delta-printer-build/ Sun, 12 May 2013 08:19:31 +0000 PunBB <![CDATA[Re: Quantum Delta printer build]]> https://www.soliforum.com/post/22560/#p22560 Is there a Q 3D forum/set up guide? Its probably going to get you satisfaction a lot quicker.

Not saying you wont get assistance here, but the trials and tribulations you'll face with that setup are markedly different to a Solidoodle... Things like the discussions on Z-Wobble, Backlash and firmware tweaks are generally in respect to a Solidoodle and are for the most part are not transferable to the Q3D besides sharing the same theories.

]]> Sun, 12 May 2013 08:19:31 +0000 https://www.soliforum.com/post/22560/#p22560 <![CDATA[Quantum Delta printer build]]> https://www.soliforum.com/post/22507/#p22507 This is my first time post and would like to share my build with you guys. I'm good at building and production but I'm very new to the software and configuration of the Delta printer.  If I could get pointers to get started it would be appreciated. So far I've loaded the Arduino with Marlin ramps1.4. I also have interface up and running and communicating with the board. But that's it , I don't know what's next.

]]> Sun, 12 May 2013 00:51:12 +0000 https://www.soliforum.com/post/22507/#p22507