<![CDATA[SoliForum - 3D Printing Community — Extruder tip hits table on start of print and jams]]> https://www.soliforum.com/topic/2332/extruder-tip-hits-table-on-start-of-print-and-jams/ Fri, 10 May 2013 01:17:51 +0000 PunBB <![CDATA[Re: Extruder tip hits table on start of print and jams]]> https://www.soliforum.com/post/22324/#p22324 saymo606 wrote:

"I'm surprised its done this out of the box as it looks like its done the test print on the bed before it was sent out."

Probably taken a knock or two on the trip over the pond smile


+1

And I have seen just the vibration in the back of semi trailer unscrew things that had tension on them... like the bed leveling screws.

]]> Fri, 10 May 2013 01:17:51 +0000 https://www.soliforum.com/post/22324/#p22324 <![CDATA[Re: Extruder tip hits table on start of print and jams]]> https://www.soliforum.com/post/22273/#p22273 "I'm surprised its done this out of the box as it looks like its done the test print on the bed before it was sent out."

Probably taken a knock or two on the trip over the pond smile

]]> Thu, 09 May 2013 15:47:43 +0000 https://www.soliforum.com/post/22273/#p22273 <![CDATA[Re: Extruder tip hits table on start of print and jams]]> https://www.soliforum.com/post/22271/#p22271 Will try now thanks, found a post about it but just nervous of braking it! Lol

]]> Thu, 09 May 2013 15:32:22 +0000 https://www.soliforum.com/post/22271/#p22271 <![CDATA[Re: Extruder tip hits table on start of print and jams]]> https://www.soliforum.com/post/22270/#p22270 Should just be a matter of adjusting the Z-axis home screw.  You can see it just to the left of the Z-axis guide rods.  I had to adjust mine right out of the box also.

]]> Thu, 09 May 2013 15:28:09 +0000 https://www.soliforum.com/post/22270/#p22270 <![CDATA[Re: Extruder tip hits table on start of print and jams]]> https://www.soliforum.com/post/22269/#p22269 Should just be a matter of adjusting the Z-axis home screw.  You can see it just to the left of the Z-axis guide rods.

]]> Thu, 09 May 2013 15:27:53 +0000 https://www.soliforum.com/post/22269/#p22269 <![CDATA[Extruder tip hits table on start of print and jams]]> https://www.soliforum.com/post/22266/#p22266 Hi i have just unpacked my Sd3 and tried printing a file. The table reset itself for printing the just collided with the bed and jammed.

I'm surprised its done this out of the box as it looks like its done the test print on the bed before it was sent out.

How do i resolve this please? Is it just a matter of screwing down the levelling screws or is it something else?

Photo attached shows the head position when i hit the home buttons on repetier.

]]> Thu, 09 May 2013 15:23:01 +0000 https://www.soliforum.com/post/22266/#p22266