<![CDATA[SoliForum - 3D Printing Community — "Lay flat" procedure?]]> https://www.soliforum.com/topic/2276/lay-flat-procedure/ Thu, 09 May 2013 00:31:30 +0000 PunBB <![CDATA[Re: "Lay flat" procedure?]]> https://www.soliforum.com/post/22219/#p22219 I've been playing with Kinect Fusion, scanning and printing busts of family members.  Netfabb makes it easy to fill the holes, cut off the excess and make a flat bottom.

]]> Thu, 09 May 2013 00:31:30 +0000 https://www.soliforum.com/post/22219/#p22219 <![CDATA[Re: "Lay flat" procedure?]]> https://www.soliforum.com/post/22204/#p22204 creationblur wrote:

Pre or post .stl?? I ask because if you want to do what i think you're talking about, I used netfabb basic to specify the "bottom" of an .stl. But that was after I had made the .stl.

I'll take either at this point smile

I'll check out netfabb basic.  Thanks for the tip...

Matt

]]> Wed, 08 May 2013 22:33:41 +0000 https://www.soliforum.com/post/22204/#p22204 <![CDATA[Re: "Lay flat" procedure?]]> https://www.soliforum.com/post/22173/#p22173 Pre or post .stl?? I ask because if you want to do what i think you're talking about, I used netfabb basic to specify the "bottom" of an .stl. But that was after I had made the .stl.

]]> Wed, 08 May 2013 17:48:15 +0000 https://www.soliforum.com/post/22173/#p22173 <![CDATA["Lay flat" procedure?]]> https://www.soliforum.com/post/21731/#p21731 Does anyone have a suggestion on how to "lay flat" an object in one of the mesh editors (e.g. MeshLab)?  I have an object that has some arbitrary tilts in it that I'd like to take out.  Cura has such a command, but I don't think I can resave the mesh.  I would have thought MeshLab could do it, but I don't find a reference to any procedure like that.

Any suggestions would be welcome.

TIA,
Matt

]]> Sat, 04 May 2013 08:49:27 +0000 https://www.soliforum.com/post/21731/#p21731