<![CDATA[SoliForum - 3D Printing Community — Best way to print this coupler?]]> https://www.soliforum.com/topic/2262/best-way-to-print-this-coupler/ Fri, 03 May 2013 15:30:55 +0000 PunBB <![CDATA[Re: Best way to print this coupler?]]> https://www.soliforum.com/post/21673/#p21673 That's a good plan.  Smaller layer sizes are inherently easier to do overhangs with since there is less extension.  You may also want to use a cooling fan, since this greatly helps in freezing the plastic in place before it curls excessively.

]]> Fri, 03 May 2013 15:30:55 +0000 https://www.soliforum.com/post/21673/#p21673 <![CDATA[Re: Best way to print this coupler?]]> https://www.soliforum.com/post/21645/#p21645 Thanks. I scaled the STL to 50% and this is the output with 0.3 mm profile with 40% infill, and 4 perimeters. I might try 0.2mm profile and increase to 5 perimeters (Slic3r 0.9.9)

]]> Fri, 03 May 2013 04:42:12 +0000 https://www.soliforum.com/post/21645/#p21645 <![CDATA[Re: Best way to print this coupler?]]> https://www.soliforum.com/post/21608/#p21608 Vertical.  I don't think you will need support, just make sure you use at least 4 perimeters.

]]> Thu, 02 May 2013 18:23:36 +0000 https://www.soliforum.com/post/21608/#p21608 <![CDATA[Best way to print this coupler?]]> https://www.soliforum.com/post/21607/#p21607 I need to print this coupler. What is the best way to do it? Do I need to enable support?

Thank you in advance for your help,

CB

]]> Thu, 02 May 2013 18:19:38 +0000 https://www.soliforum.com/post/21607/#p21607