<![CDATA[SoliForum - 3D Printing Community — Extruder does turn on when printing]]> https://www.soliforum.com/topic/2248/extruder-does-turn-on-when-printing/ Wed, 01 May 2013 01:43:36 +0000 PunBB <![CDATA[Re: Extruder does turn on when printing]]> https://www.soliforum.com/post/21495/#p21495 There is a 'test' button somewhere near the bottom?? of the screen IIRC that disables extrusion for testing print runs... is this clicked?

EDIT: Ok I just checked it is called 'Dry Run' located in the bottom right of the manual control tab in repetier host... if it isn't this then the stepper motor shaft may be slipping inside the filament drive gear use the manual extrude buttons to check on this.

]]> Wed, 01 May 2013 01:43:36 +0000 https://www.soliforum.com/post/21495/#p21495 <![CDATA[Re: Extruder does turn on when printing]]> https://www.soliforum.com/post/21491/#p21491 Did you click "heat extruder" in manual control?

]]> Wed, 01 May 2013 01:16:42 +0000 https://www.soliforum.com/post/21491/#p21491 <![CDATA[Re: Extruder does turn on when printing]]> https://www.soliforum.com/post/21490/#p21490 Has the extruder ever worked for your before?
Are you using Repetier-Host?

]]> Wed, 01 May 2013 01:10:13 +0000 https://www.soliforum.com/post/21490/#p21490 <![CDATA[Re: Extruder does turn on when printing]]> https://www.soliforum.com/post/21487/#p21487 Is there a G code that is not being added? Do I have a button turned off?

]]> Wed, 01 May 2013 00:48:15 +0000 https://www.soliforum.com/post/21487/#p21487 <![CDATA[Re: Extruder does turn on when printing]]> https://www.soliforum.com/post/21486/#p21486 I ment to say the Extruder does not turn on.

]]> Wed, 01 May 2013 00:47:25 +0000 https://www.soliforum.com/post/21486/#p21486 <![CDATA[Extruder does turn on when printing]]> https://www.soliforum.com/post/21485/#p21485 Extruder does turn on when printing. X,Y, and z are runing fine. but no ABS extruded. ?

]]> Wed, 01 May 2013 00:44:27 +0000 https://www.soliforum.com/post/21485/#p21485