<![CDATA[SoliForum - 3D Printing Community — SD2 Firmware Update Issue]]> https://www.soliforum.com/topic/2082/sd2-firmware-update-issue/ Tue, 16 Apr 2013 02:18:31 +0000 PunBB <![CDATA[Re: SD2 Firmware Update Issue]]> https://www.soliforum.com/post/20082/#p20082 I re-installed everything again and seemed to have fixed the problem...

]]> Tue, 16 Apr 2013 02:18:31 +0000 https://www.soliforum.com/post/20082/#p20082 <![CDATA[Re: SD2 Firmware Update Issue]]> https://www.soliforum.com/post/19979/#p19979 A few more specifics would certainly help... win/mac/linux? what are you trying to flash the FW with?

But usually this is caused by no comms to the arduino/sanguino, first thing to check is what port it is on... this can change after a reset; second if no extra ports are showing up reinstall the ftdi drivers and make sure the usb plugs are seated on both ends.

]]> Mon, 15 Apr 2013 04:04:54 +0000 https://www.soliforum.com/post/19979/#p19979 <![CDATA[Re: SD2 Firmware Update Issue]]> https://www.soliforum.com/post/19974/#p19974 Now that I have tried to uninstall the recommended Solidoodle Software, I can't connect to my SD2.

Anyone know what I did wrong to mess up this much??
I even tried to flash the firmware, but I am having similar issues in that I can no longer connect to my printer... : (

]]> Mon, 15 Apr 2013 02:59:33 +0000 https://www.soliforum.com/post/19974/#p19974 <![CDATA[SD2 Firmware Update Issue]]> https://www.soliforum.com/post/19936/#p19936 Hello,
I keep recieving the following error message when I try to flash my firmware onto the SD2:

avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

I noticed there are other people who have experienced this error.  But no one seems to have solved the problem.

Anyone know what is going on??

]]> Sun, 14 Apr 2013 22:38:06 +0000 https://www.soliforum.com/post/19936/#p19936